SOLID COLOR QUARTZ

Double Broadcast Solid Color Quartz Single Broadcast Solid Color Quartz

Click on photo to enlarge.

Installation Process:    Click here to see the surface preparation process for residential projects. Click here to see the surface preparation process for commercial/industrial projects.

Double Broadcast Solid Color Quartz (~ 3/32" to ~ 1/8”) First Coat: • Apply a clear binder coat of 100% solids epoxy to floor surface (~ 160 sq. ft. per gal.) • While the binder coat is still wet, broadcast natural quartz sand to rejection • Allow epoxy coat to cure for about 24 hours • Sweep off any loose sand Second Coat: • Apply a clear binder coat of 100% solids epoxy to floor surface (~ 120 sq. ft. per gal.) • While the binder coat is still wet, broadcast natural quartz sand to rejection • Allow epoxy coat to cure for about 24 hours • Sweep off and vacuum any loose sand Third Coat: • Apply a coat of pigmented 100% solids epoxy (80 to 120 sq. ft. per gal.) or high solids polyurethane (250 to 300 sq. ft. per gal.) to floor surface • Allow to cure for about 24 hours • Lightly sand (either mechanically or by hand) the floor to remove any foreign debris trapped in the drying process and smooth the surface (if necessary) Fifth Coat (Optional coat to create smoother profile): • Apply a pigmented coat of UV resistant polyurethane with aluminum oxide (added for slip resistance) to floor surface (250 to 300 sq. ft. per gal.)

Single Broadcast Solid Color Quartz (~ 1/16”) First Coat: • Apply deep penetrating epoxy primer to floor surface (250 to 350 sq. ft. per gal.) • Allow primer to cure for about 1 to 24 hours • Lightly sand (either mechanically or by hand) the floor to remove any foreign debris trapped in the drying process and smooth the surface (if necessary) Second Coat: • Apply a clear binder coat of 100% solids epoxy to floor surface (~150 sq. ft. per gal.)   • While the binder coat is still wet, broadcast natural quartz sand to rejection • Allow epoxy coat to cure for about 24 hours • Sweep off and vacuum any loose sand Third Coat: • Apply a coat of pigmented 100% solids epoxy (80 to 120 sq. ft. per gal.) or high solids polyurethane (250 to 300 sq. ft. per gal.) to floor surface • Allow to cure for about 24 hours • Lightly sand (either mechanically or by hand) the floor to remove any foreign debris trapped in the drying process and smooth the surface (if necessary) Fourth Coat (Optional to create smoother profile): • Apply a pigmented coat of UV resistant polyurethane with aluminum oxide (added for slip resistance) to floor surface (250 to 300 sq. ft. per gal.)

Ervin Specialty Coatings  |  Cottonwood, AZ  |  (928) 649-9338  | ROC218645  ROC220641